Case details
A buyer in Kuwait needed a metal four-ring mechanism for document binders. They sent the model reference, dimensions and photos. The factory had to produce a specific gold colour by electroplating and meet a short lead time. We did not send a physical sample to the buyer for this order.
The buyer's reference photo shows the four rings and the full fitting alongside a steel ruler.
Agreeing the finish before placing the order
Several suppliers could make the fitting. Fewer could produce the specified electroplated finish. We found a factory in Foshan that could do the work, agreed on the price and lead time, then visited before placing the order to check the model, dimensions, material and finish in person.
The shade can vary between plating runs. We asked the factory to plate the order in a single batch to reduce that risk.
What the buyer checked before paying
When the fittings were ready, we asked the factory to photograph them and recheck their dimensions with calipers. The measurement photo shows the jaws against the two sides of the metal base. The 26.3 mm reading is the width of that base.
We also checked the mounting rivets with the buyer. These small parts fasten the metal mechanism to the binder cover. In the packing photo, the red circle marks the bag of rivets in the carton.
Shipment to Kuwait and a repeat order
The buyer approved the fittings and rivets, then paid us. We paid the factory and arranged air freight to Kuwait. The team member who handled the order reported that the buyer ordered the same fitting again about six months later.
If you need to match an existing fitting, send us your photos and specifications. A photo of the full mechanism, a close-up of the fasteners, the finish and your target date will help us identify what to check with the factory.
